TREAD RUBBER REVERSION

PHENOMENON

A patch of tread rubber is melted or scorched.

POSSIBLE CAUSES

An oval shaped burn on the tread most often is caused by hydroplaning on wet or frozen runways during landing.

RECOMMENDATION

If the tread rubber reversion reaches the reinforcing fabric (bias) or aramid cord protector (radial), remove the tire from the aircraft.

If the tread rubber reversion does not reach the reinforcing fabric (bias) or aramid cord protector (radial), if there is sufficient groove depth in the whole tread rubber reversion area, if there is hot incipient separation and if vibration is not detected while rolling, leave the tire on the aircraft.

Check Another Projects

TREAD SEPARATION
SPOT WEAR